• Designed for 9.9 – 4 stroke high thrust motors with power tilt
• Suitable for 2 cycle motors up to 20 HP.
• No moving parts or bracket – nothing to wear out
• Use the built in tilting devise to tilt your motor up and down
• High-grade marine aluminum alloy electro statically powder coated in white

Designed for 9.9 high thrust four-stroke outboard motors, maximum weight 140 pounds. Suitable for 2 cycle outboard motors up to 20 HP. No moving parts, high grade aluminum alloy. Welded inside and out.

Electrostatically powder coated in white. Polypropylene mounting pads, all fasteners stainless steel. The built-in tilting device of the outboard motor is used to tilt the outboard motor "back" and clear the skeg from water.

No parts to wear out, easy operation, easy to install. 21 1/2" long, 12 1/2" wide, 17" transom to center mounting pad. Transom mounting flange 12 1/2" wide by 8" high. Shipping weight 21 lbs. 8 oz.

Designed for 9.9 hp high thrust four-stroke outboard motors for mounting on a swim step. Constructed of marine grade aluminum alloy and powder coated electrostatically in white for corrosion protection.

Mounting pads of polypropylene, fasteners of stainless steel. Welded inside and out. Maximum 9.9 HP high thrust. 4 stroke motor. Suitable for 2-cycle outboard motors up to 20 HP Max. and 140 lb. maximum weight. 14" wide by 13" deep. 7" high 4 1/2" above swim step.
Shipping weight: 11 lbs 8 oz.

• Auxiliary motor bracket for power or sailboats
• Transom mount. For outboard motors to 8 HP, two cycle or four stroke
• Maximum weight 60 lbs
• Made of 6061-T6 Marine aluminum. Tube 5 1/2" diameter, 1/4" thick
• Polypropylene motor mount. Bracket 14" long. Mounting flange 7" high by 8" wide. Shipping weight: 9 lbs. 6 oz.
• For Power or Sailboats