FAQ - Stabilizer
Will it fit my motor?
What is the cost?
What material is it made of?
How is it installed?
What tools do I need?
What benefits will I get from the Stabilizer?
Will the Stabilizer work for water-skiing?
Will visibility be better?
May the product be returned if not satisfactory?
What is the warranty?
Q: Will it fit my motor?
A: We make 3 sizes, Model 1000 from 4 to 12 HP, Model 1100 from 15 to 130 HP
and Model 1200 from 150 to 200 HP.
Model |
Cost (USD) |
1000 |
$72.00 |
1100 |
$85.00 |
1200 |
$95.00 |
Q: What material is it made of?
A: High grade marine aluminum alloy 6061-T6, electro statically powder coated in black.
Q: How is it installed?
A: With 6 – ¼” stainless steel cap screws and lock nuts. 3 on each side of the anti-cavitation
plate. The Stabilizer is installed below the anti-cavitation plate, in about 30- 40 minutes. All fasteners supplied.
Q: What tools do I need?
A: An electric hand drill, 5/16” high speed drill bit and two 7/16” open end wrenches.
Q: What benefits will I get from the Stabilizer?
A: The Adventure Stabilizer is “thin” and therefore does create very little friction and drag. Similar products made of plastic with “thick” frontal area create a lot of drag and loss of speed, specially at high RPM. You will notice less fuel consumption at all speeds. At high speed up to 20% or better. Therefore less wear on the motor. You will get “out of the hole faster“ and reduce if not eliminate “ porpoising “. Once you have reached planing speed, you can reduce RPM and still maintain same planing speed.
Q: Will the Stabilizer work for water-skiing?
A: Yes – extremely well. You will be up faster with less effort. Much less wake. Smoother water to ski on.
Q: Will visibility be better?
A: Yes – with the bow of the boat down, the driver can see better and it is safer.
Q: May I return the product of not satisfactory?
A: Yes Click here for more information on our return policy
Q: What is the warranty?
A: Click here for more Information
